S7-SoftPLC:cifX PROFIBUS® configuration via S7 for Windows®/STEP®7

From IBHsoftec Wiki English
Jump to: navigation, search

User Interface

PROFIBUS<sup>®</sup> Konfiguration aus S7-SoftSPS übernehmen


Use PROFIBUS® configuration from PLC

Takes the PROFIBUS® configuration created with S7 for Windows®/STEP®7. The bus will be configured and operated with these parameters from the PLC.


Enable PU/OP functions via PROFIBUS® DP

Allows a PU-communication via the PROFIBUS® to S7-SoftPLC. Some OP's (as e.g. OP3) use PU-communication for data exchange with the PLC, so that these panels can be used as well. 1)


Activate DPV-1 functions on the PROFIBUS®

Allows sending and receiving DPV1 functions to DPV1 slaves. SFB52 and SFB53 are available for DPV1 services.*


1) The bus configuration has to be created with S7 for Windows® hardware configuration or STEP®7 hardware configuration.
The configuration has to be created exclusively with General Station Description (GSD)


Settings

In the section [CIFX] PROFIBUS® specific settings are conducted. The settings are necessary, if the bus configuration is to be created with the S7 for Windows® hardware configuration or the STEP®7 hardware configuration.

Keyname Value range Default value Description
B##C##SDBConf 0 / 1 0 Use PROFIBUS® configuration from PLC

0 = No, 1 = Yes

B##C##DPV1Active 0 / 1 0 1=Allows sending and receiving DPV1 functions to DVP1 slaves. SFB52 and SFB53 are available for DPV1 services.
B##C##PBPGOPActive 0 / 1 0 1=Allows a PU-communication via the PROFIBUS® to S7-SoftPLC. Some OP's (as e.g. OP3) use PU-communication for data exchange with the PLC, so that these panels can be used as well.