IBHNet:Technical Data IBH Link S7++/S7++ HS

The IBH Link S7++ and the IBH Link S7++ HS have the same technical details except the following points:

• The IBH Link S7++ HS has a rail mount.
• The IBH Link S7++ HS has to be supplied with external 24V. The IBH Link S7++ can get the 24V from the MPI^®/DP interface.
• The "APL"-LED of the IBH Link S7++ HS is equal to the "COM"-LED of the IBH Link S7++.
• The IBH Link S7++ HS has a rotary address switch to set the MPI^®/DP-Address. A configured address in the range of 0-98 disables the address configuration with IBHNet. The MPI^®/DP-Address 99 enables the the address configuration with IBHNet. The MPI^®/DP-Address is taken from the rotary address switch only during a power cycle of the IBH Link S7++ HS.

Features:

• Configuration via web browser
• Configuration via NetPro
• Windows^®7 64 Bit support
• STEP^®7 64 Bit support
• PROFIBUS diagnostics
• Slave diagnostics
• Drive configuration
• Setting of the Slave Parameters via DPV1
• Integration within the TIA portal
• Routing via RFC1006
• PLC - PLC communication
• Process data access with other PLCs, Windows and Linux
• 16 PC-connections at the same time
• 32 MPI^® / DP-connections at the same time
• Automatic Baudrate detection
• PG(PU)-connector (IBH Link S7++ only)
• RJ45-Plug with autodetect integrated
• Power supply from the MPI^® / DP interface
• Connection also to passive nodes with power supply via integrated 24V connector
• DHCP
• Diagnostic LEDs
• Time synchronisation
• Data set routing

Ethernet Interface

Ethernet pinout of the RJ45 female connector:

Pin	Signal	Meaning
1	TD+	Receive Data +
2	TD-	Receive Data -
3	RD+	Transmit Data +
4	n.c.	not used
5	n.c.	not used
6	RD-	Transmit Data -
7	n.c.	not used
8	n.c.	not used

Ethernet Connection Data

Topology	Star Topology
Medium	4 x 2 Twisted Pair copper cable Cat 3 (10 MBit/s), Cat 5 (100 MBit/s)
Length of cable	100m to the Device or to the next Hub and Switch respectively
Transmission rate	10 MBit/s / 100 MBit/s

 

Direct Connection

Connection via Hub/Switch

 

Technical data

Ethernet Interface
Transmission rate	10 / 100 MBit/s
Interface	max. 100 Base-TX potential free
Connector	RJ45 female connector
PROFIBUS-Interface
Transmission rate	RS485, max. 12 MBit/s

     Attention

The IBH Link S7++ only requires 24 VDC if not supplied by the PLC. Pay attention to polarity.

Meaning of LED-Signals

The COM-LED of the IBH Link S7++ and the IBH Link S7++ HS can be used for test functionality of the SIMATIC^® Manager (PLC, Edit Ethernet Node).

Display Status IBH Link S7++