Difference between revisions of "IBHLink S7++ S7-300/S7-400 Elipse Scada"
| Line 30: | Line 30: | ||
The ethernet communication driver for S7-300/400 named '''MProt.dll''' must be selected witin the Application Organizer: | The ethernet communication driver for S7-300/400 named '''MProt.dll''' must be selected witin the Application Organizer: | ||
| − | [[Image: | + | [[Image:Elipse_driver.png|600px]] |
If you are using the WinCC flexible Runtime, please check that in the settings of the PG/PC Interface the correct driver ''TCP/IP'' for the Access Point ''S7ONLINE'' is chosen. | If you are using the WinCC flexible Runtime, please check that in the settings of the PG/PC Interface the correct driver ''TCP/IP'' for the Access Point ''S7ONLINE'' is chosen. | ||
Revision as of 12:58, 4 June 2012
It is possible to realize a connection from a PC with Elipse Scada to a S7-300/400 station over ethernet using an IBHLink S7++ as gateway.
Example
In the following example a configuration with Elipse Scada is shown. The HMI station is connected to the IBHLink S7++ via an Ethernet connection. The IBHLink S7++ itself is connected to a S7-300/S7-400 station by MPI or PROFIBUS. Bus parameters were configured by the IBHNet configuration tool.
The following addresses were chosen in the example:
IP addresses:
| Station | Address |
|---|---|
| HMI station | 192.168.10.122 |
| IBHLink S7++ | 192.168.10.125 |
PPI addresses:
| Station | Address |
|---|---|
| IBHLink S7++ | 17 |
| S7-300/S7-400 station | 2 |
Configuration:
The ethernet communication driver for S7-300/400 named MProt.dll must be selected witin the Application Organizer:
If you are using the WinCC flexible Runtime, please check that in the settings of the PG/PC Interface the correct driver TCP/IP for the Access Point S7ONLINE is chosen.
The configuration of the connection is now completed and you can continue with defining your Tags.
